Author: Biallas, G.H.
Paper Title Page
THPTEV012 Substitution of Spring Clamps for Bolts on SRF Cavity Flanges to Minimize Particle Generation 853
 
  • G.H. Biallas
    Hyperboloid LLC, Yorktown, Virginia, USA
  • E. Daly, K. Macha, C.E. Reece
    JLab, Newport News, Virginia, USA
 
  Funding: Funding supplied by US Department of Energy SBIR Grant #DE-SC0019579
Hyperboloid LLC developed and successfully tested a System of High Force Spring Clamps to substitute, one for one, for bolts on the flanges of SRF Cavities. The Clamps are like exceptionally forceful binder clips. The System, that includes the Hydraulic Openers that apply the clamps, minimizes generation of particulates when sealing cavity flanges. Hyperboloid LLC used ANSYS to design the titanium clamps that generate the force to seal the hexagonal cross section, relatively hard aluminum gasket developed for TESLA and used at JLab and other accelerators. The System is developed to be suitable for use in SRF Clean Rooms. Results of particle counter readings during bolt and clamp installation and superfluid helium challenges to the sealed flanges are discussed. Results of a half-size clamp that could seal a soft aluminum gasket and the attempt to seal a gasket made of niobium are also discussed.
L. Monaco, P. Michelato, C. Pagani, N. Panzeri, Experimental and Theoretical Analysis of Tesla-like SFRF Cavity Flanges, INFN Milano- LASA, I-20090 Segrate (MI), Italy. Proc. EPAC 2006, Edinburgh, SC
 
poster icon Poster THPTEV012 [1.400 MB]  
DOI • reference for this paper ※ https://doi.org/10.18429/JACoW-SRF2021-THPTEV012  
About • Received ※ 21 June 2021 — Revised ※ 16 December 2021 — Accepted ※ 28 April 2022 — Issue date ※ 01 May 2022
Cite • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)